Get your stereo speaker system working again in less than 30 minutes
You’vecorrectly arranged your new speakers.
All the cables have been meticulously connected.
Each piece of equipment has been switched on.
Then, you hit “play” on the audio source, yet nothing happens.
But don’t toss your remote at the wall just yet.
Instead, try these troubleshooting tips to get your brand new sound system up and working.
Double-check that wall switches operating any outlets are flipped on.
If something doesn’t power up, test it with another outlet that you know functions properly.
It’s a good idea to connect equipment to outlets that don’t have wall switches.
Check the speaker/source selection.
Many receivers have aSpeaker B switch for adding more speakers.
ensure that the right ones are enabled, and check that the correct source has been selected.
Inspect the bare ends to ensure that enough insulation is stripped off.
If possible, connect the speakers to another working audio source to ensure that they still operate correctly.
If the speakers still don’t play, they may be damaged or defective.
If they do play, reconnect them to the system and continue.
Check the source components.
If the machine still doesn’t play properly, then your problem is most likely with the machine.
Toggle through each input source on the stereo receiver one by one.
Replace any suspect cables and try the original component again.
That’s why it’s important to proceed through these troubleshooting steps in the proper order.
The following steps will help guide you through the most common problems.
Remember to alwaysturn off the power to the system and componentsbefore connecting or disconnecting cables and wires.
Then turn the power back on after each step to check for correct operation.
Be sure to leave the volume low, lest you blast your ears once the audio is on.
